My car is showing this engine/emissions warning. What could it be?

Question

Answer 1

During drive v arha hy ??

Comments

yes

---

Then checkup krvaein ... if it is not showing during driving to koi issue ni

Answer 2

which car you are using

Comments

Mira

Answer 3

Get it scanned from some good Workshop / electrician for accurate identification ... Any of the sensor is not working properly.... It appears in My Passo & Oxygen Sensor was faulty

Answer 4

Koi sensor week ho gya ha. I think apne koi kam krwaya ha front se. Isay thek krne k liay bettery ki wire nikal k again lagao

Comments

Service karwai thi bro.

---

Haris Aziz woi issue ha. Just bettery ki wire utaro like circuit brake karo n again lga do. Thek ho jae ga

---

Alright. Thank you :)

---

Haris Aziz kr k Btao hui k ni. Hardly it will take 2 mints

---

Zarar tu b ye try kr k dekh

Answer 5

this is engine check light, if any sensor is not reading correctly then car's computer raises relevant error code and gives you a check light in dash. on check light you need to scan it with obd scaner..

Answer 6

Most probably mass air flow sensor needs cleaning

Answer 7

The battery terminal *might* be loose. You can try the following to fix the problem: 1. Turn off your car engine. 2. Remove the battery terminal. 3. Wait for 30 seconds. 4. Attach the battery terminal back. The engine light *may* go off now. If this doesn't fix your problem them you may need to take your car for tuning. Goodluck!

Comments

Ill try it. Thank you

---

I had this same problem with my Mira eis... so the above instructions worked for me. To be specific I removed the negative terminal of the battery for like 1 min and after connecting, the problem solved.

Answer 8

Maintenance required

Answer 9

Negative terminal nikaal kay wapis lagao, may be sahi hojae, same i faces with nissan dayz couple of dayz ago

Answer 10

No such light in my car

Answer 11

which car?

Comments

Mira

Answer 12

Haris Aziz What you first do it reset the car, to reset car you can disconnect battery one terminal from car and leave it for 10 minutes. Reconnect it and start car. The sign will go away (40%). If it did not or appear again, get it scanned from a workshop. The scanner will identify the cause of the error sign, it can be anything in the car.

Answer 13

I had same issue, In mu case, problem was with oxygen sensor. But you can scan the problem by using ODB2 dongle which will plug to your car’s ODB2 socket, by using android/IOS app you can see the result.